- May 16, 2018 -
Frequently used failures and exclusions:
Insufficient spray pressure, poor atomization: If the water inlet valve is put aside by dirt, the inlet valve can be removed and the dirt can be removed with a cloth. If the skin is damaged, the new skin can be replaced; if the connection site is not installed Seals, or leaks due to seal damage, can be added or replaced.
Spray can not fog: if the inclined hole of the nozzle body is blocked by dirt, can clear the oblique hole; if the nozzle hole can be opened due to plugging of the cleaning hole, but can not use the wire or copper needle and other hard objects to spray hole, prevent the hole expansion The quality of the spray will be degraded; if the filter is clogged inside the casing or the ball of the over-water valve is set aside, the filter should be cleaned and the dirt that has left the ball should be cleaned.
If the switch cap is not tightened, the switch cap should be tightened; if the washer on the switch core is worn out, the gasket should be replaced; the switch can't be turned because of a long time, or the switch is used for too long. The core is bound due to the corrosion of the chemicals. The parts should be removed and cleaned in kerosene or diesel oil. When it is difficult to remove, it can be soaked in kerosene for a period of time, and then it can be removed and disassembled. It cannot be struck with hard objects.
Leakage at each connection: If the connector is loose, tighten the nut. If the gasket is not flat or damaged, the gasket should be leveled or the gasket replaced. If the gasket shrinks and hardens, it can be used after dipping in animal oil. .